- Garrard Turntable Manuals
- Garrard 1212 Turntable User Manual
- Garrard Turntable Repair
- Garrard 440m Turntable Manual
- Garrard 1212 Turntable Manual
Page 9
Vintage Garrard England DDQ-650 Semi-automatic Direct-drive Turntable. Top Rated Seller. Top Rated Seller. Was: Previous Price. C $603.77 10% off.
When the cartridge is in position see that the pointer on the side
of the pickup arm, indicating stylus pressure, is set to its rear position,
i.e. no stylus pressure spring tension. If not, set the pointer to this
condition by turning the adjusting screw under the arm counterclock-
wise, looking from overhead.
- Garrard Model 5-3000 Turntable Motor, Grommets, C-clips, From KLH Model 34. Top Rated Seller. Top Rated Seller. Was: Previous Price. C $41.87 10% off. From United States.
- Hifi Manuals Free The vintage hifi free downloads: Looking for information about your vintage stereo equipment, your vintage amp! Vintage hifi the website offers you the possibility to download: manuals, service manual, owners manual, operating instructions, diagrams, test benches, brochures, catalogs among 101 brands list below, without limitation without registration.
Next, with the pickup arm perfectly free to pivot up and down,
adjust the position of the counterbalance weight, by loosening its locking
screw and sliding the weight along the arm until the arm balances
horizontally, then tighten the locking screw.
Garrard Turntable Manuals
The stylus pressure required is then applied by turning the adjusting
screw under the arm clockwise, each click representing an increment of
approximately 5- gram and the markings representing approximately 0
to 5 grams.
Garrard 1212 Turntable User Manual
Since the pickup arm skating force, which manifests itself when
there is low pivot friction, is related to stylus pressure, the bias com-
pensator setting will depend on the stylus pressure previously applied.
The longer arm of the bias compensator, carrying a setting weight, is
notched according to stylus pressure. The notches represent approx-
imately I to 5 grams from inner to outer notch. The setting weight
should be set to the appropriate notch. Grip the side of the setting
weight when adjusting its position and do not slide it nearer to the arm
pivot than is necessary.
Garrard Turntable Repair
Fitting Cartridge
A plug in pickup shell, designated M8, is used on the Type A70.
This may be supplied with or without a pickup cartridge. The pickup
head kit, part number 71208, comprises pickup shell, less cartridge and
accessory kit, part number 71216, allowing a wide range of cartridges
to be fitted.
The accessory kit consists of three alternative pairs of screws, two
washers, two spacers and a weight. The cartridge should be secured
centrally to the pickup shell using the screws of the appropriate length.
Use the washers under the screw heads if the holes in the cartridge har-
ness are larger than the screw heads. Use the spacers between cartridge
and pickup shell if more clearance is required. Use the weight as ballast
if a lightweight cartridge is fitted weighing less than 5 grams.
GREEN LEAD CARTRIDGE FIXING
BLUE LEAD scaew HOLES
WHITE LEAD
RED LEAD
Garrard 440m Turntable Manual
Diagram 4
M8 PICKUP SHELL
Garrard 1212 Turntable Manual
Seven